Gas ducted heating has kept a lot of Melbourne homes warm for decades. But more households are swapping it for electric reverse-cycle air con, and it's worth understanding why before your old unit gives up on a cold July night.
Why Melbourne homes are moving away from gas ducted heating
There's no single reason. For most people it's a mix of cost, comfort and wanting fewer bills to juggle.
Gas prices. Gas has become a bigger line item for many Victorian households, and the daily supply charge is there whether you use much gas or not. Once heating goes electric, the gas bill often becomes hard to justify.
Efficiency. A gas heater burns fuel to make heat. A reverse-cycle system is a heat pump: it moves heat from the outside air into your home. Modern systems typically deliver around three to four units of heat for every unit of electricity they use. That's a big part of why electric heating has become such a strong option.
You get cooling too. Gas ducted only heats. A reverse-cycle system heats in winter and cools in summer from the same unit, so you're not paying for one system and putting up with portable fans or a separate wall unit for the hot spells.
It pairs well with solar. If you have solar panels, or are thinking about them, electric heating and cooling lets you put your own power to work. Run the system on a timer to pre-cool or pre-warm the house while the sun's out, and you lean less on the grid in the evening. Our guide on how much solar you need covers how to size a system with electric heating in mind.
Ducted reverse-cycle or split systems: what replaces gas ducted?
You've got two main paths, and plenty of homes use a bit of both.
Ducted reverse-cycle is the closest like-for-like swap. One outdoor unit, an indoor unit in the roof space, and vents in each room. It's discreet, it can be zoned so you only heat or cool the rooms you're using, and it feels familiar if you're used to gas ducted.
Split systems put a wall-mounted head in the rooms that matter most, usually the living area and bedrooms. They're often simpler to install and can be a sensible choice if you mostly live in a few rooms. We compare the two in detail in split system vs ducted air con.
The right answer depends on your floor plan, how many rooms you actually use, and whether there's good roof space to work with. That's why we start with a chat and a home check rather than a one-size answer.
Can you reuse your existing gas heating ducts?
This is the question we get asked most. The honest answer is: sometimes, partly, and it depends on what's there.
Gas ducted systems were designed for heating only. Reverse-cycle systems also push cool air, and that brings a few extra needs.
- Insulation. Cool air running through poorly insulated ducts in a hot roof can lose a lot of its effect and may cause condensation. Older ducts often aren't up to it.
- Size and airflow. Reverse-cycle systems usually move more air than gas heaters. Ducts that are too small or poorly laid out can be noisy and less efficient.
- Condition. Ducts sag, split and get damaged by pests over the years. Leaky ducts waste energy no matter what's heating the air.
- Floor vents. Plenty of older Melbourne homes have floor vents with ducts under the house. They're fine for heating, but cool air sinks, so cooling from the floor is less effective. Many homes switch to ceiling outlets.
In good condition, some ductwork and outlet positions can be kept. Often it's better to replace the ducts with properly insulated ones sized for the new system. We'll check what you have and tell you straight.
What the install involves
A gas-to-electric changeover is usually simpler than people expect. In broad strokes:
- Home check and sizing. We look at your rooms, insulation, roof space, ducts and switchboard, then size a system that suits the home rather than guessing from floor area alone.
- Removing the old heater. The gas ducted unit is disconnected and taken out. A licensed gas fitter makes the gas line safe.
- Installing the new system. The indoor unit goes in the roof (for ducted) or on the walls (for splits), the outdoor unit goes outside, and ducts, refrigerant pipes and drainage are run.
- Electrical work. The system gets its own dedicated circuit. Sometimes the switchboard needs an upgrade, which we'll flag up front.
- Commissioning and handover. We test everything, set up zones and controls, and show you how to use it.
Our own licensed team does the work, not subcontractors, so the people who quote are the people accountable for the job. You can see more on our heating and cooling page.
Abolishing the gas connection
If heating is your last gas appliance, or you're also replacing your gas hot water and cooktop, you can consider getting rid of gas altogether.
There's a difference between a disconnection and an abolishment. A disconnection generally turns off the supply but leaves the meter in place. An abolishment permanently removes the meter and connection, which means you stop paying a daily gas supply charge. You usually arrange it through your gas retailer. There can be a fee and some lead time, so check with them before you plan around a date.
Many households do it in stages: heating first, then hot water, then the cooktop. If hot water is next on your list, have a read of how heat pump hot water works.
Rebates for replacing gas heating in Victoria
There are incentives available for switching from gas to efficient electric heating in Victoria, mainly through Solar Victoria rebates and the Victorian Energy Upgrades program. Depending on your home and eligibility, you may be able to get up to $8,000 in rebates for swapping gas ducted heating to electric.
Rebate amounts and rules change often, and what you qualify for depends on things like your property and what you're replacing. The easiest way to get a current picture is our rebate checker, or ask us during your home check and we'll factor it into your quote.
Common questions
Will reverse-cycle air con keep my house warm in a Melbourne winter?
Yes, when it's sized properly for the home. Modern reverse-cycle systems are designed to heat well in cold conditions. Good sizing, insulation and sensible zoning make the biggest difference to comfort.
How long does a gas ducted to reverse-cycle changeover take?
Many installs are done in a day or two, depending on whether ducts are being replaced and if any electrical upgrades are needed. We'll give you a clear timeline with your quote.
Do I have to remove all my gas appliances at once?
No. You can switch heating now and leave hot water or cooking on gas for later. Just keep in mind you'll keep paying a gas supply charge until the last gas appliance goes and the connection is abolished.
Talk to a local team
We're based in Clayton and install heating and cooling across Melbourne and Victoria, with more than 12,000 happy customers and a 5.0 Google rating. If your gas ducted heater is getting on, we'll come out, look at your home and give you honest options. Get energy advice or give us a bell on 1300 289 803.